PB Blackhole questions

[dynamic73]

Now that I`ve got my car polished and LSP ready. I want to use PB Blackhole glaze to enhance the shine, before I use DGPS 3.0. Would it be a good thing to use the Blackhole and allow it to cure for 24 hrs, before using the DGPS 3.0?



Also I read that it`s better to apply it with a PC, than by hand. Is it really best to do it this way? I don`t want to make a mess again. Like when I did the polishing with Meg`s M105/M205 combo. Took me a couple of hours to clean all that compound off.

[dlt21]

Reply I got from Poorboys re cure time and lsp wax vs sealant



Hi David,



No, there is no cure time for Black Hole ... the look will last about the same as the LSP you use ... so technically, yes it should last a bit longer with a sealant.

--

regards



Steve

Poorboy`s World Products

poorboysworld.com = site

poorboysworld.net • Index page = forum

[dynamic73]

Ok I`ll just apply my sealant right after the Black Hole. Thanks

[imported_Larry A]

Can NXT2, Mothers FX, and Duragloss 105 , be used after Black Hole, or will these sealants remove the BH?

[getcha]

NXT will probably start to chemically clean it as it does have some cleaners plus, FX the spray I assume you mean should be OK and 105 from DG does have a bit of cleaning but I personally wouldnt think it would have any significant effect. Though I would be curious(and start with a section start to finish first) to see if any of these had any negative bonding issues in general